How to make your own texturz plate for your Big Shot

By | April 19, 2010

Good Morning Stampers

Opener

I was looking at DOstamping with Dawn's blog the other day and she showed how to make your own texturz plate for the Big Shot so I decided to try it.  I used the Tulipe Bigz Die because it's one of my favorite dies. 

Tulipe-Die-Cut

What I Did:

  • To create the texturz plate, I glued two six by six inch pieces of the cardboard backing from the Designer Series Sentiment  
    Paper. I fed it through the Big Shot using the Tulipe Bigz Die and voila! I had my texturz plate!
  • The base card is Bashful Blue card stock folded in half.
  • The Naturals Ivory card stock (6 x 6) was fed through the Big Shot using my homemade texturz plate. After I cut it down to about 4 l/2" x 4 3/4", I punched out the corners using the Scallop Border Punch.
  • The sentiment was stamped with Bashful Blue Classic Ink on Naturals Ivory card stock and punched out with the Scallop Oval Punch
  • Adhere together as shown in photo.

Thanks for stopping by today.

Brumleysiggy 

To buy any of the supplies for this card or to shop 24/7, visit my Stampin' Store

Supplies:

Supplies Stamp Set: Oval All (113790) Paper: Naturals Ivory card stock (101849), Bashful Blue card stock (105120) Ink: Bashful Blue Classic Ink (105209) Accessories: Scallop Oval Punch (114889), Scallop Trim Corner Punch (118870), Tulipe Bigz Die (113457), Big Shot (113439), Mini Glue Dots (103683), Stampin' Dimensionals (104430)

 

 

Oval-All

 

 

3 thoughts on “How to make your own texturz plate for your Big Shot

Leave a Reply

Your email address will not be published. Required fields are marked *